⚠️ This forum has been restored as a read-only archive so the knowledge shared by the community over many years remains available. New registrations and posting are disabled.

All times are UTC + 8 hours




Post new topic Reply to topic  [ 25 posts ]  Go to page Previous  1, 2
Author Message
 Post subject: Re: Cinder Block Tanks
PostPosted: Mar 15th, '11, 16:07 
Bordering on Legend
Bordering on Legend
User avatar

Joined: May 10th, '10, 21:46
Posts: 453
Gender: Male
Are you human?: After midday.
Location: West Australia
Filling the blocks with concrete will add a lot of strength. Can then seal it with liner or a paintable sealer. I used a rubber based one called pondseal that is flexible to a degree on my concrete tank.

Formwork unless you can reuse the timber does add up in cost.


Top
 Profile  
Reply with quote  
    Advertisement
 
 Post subject: Re: Cinder Block Tanks
PostPosted: Mar 16th, '11, 15:39 
Bordering on Legend
Bordering on Legend
User avatar

Joined: Jul 1st, '10, 21:20
Posts: 324
Location: Discovery Coast Qld
Gender: Male
Are you human?: occasionally
Location: Qld.
Ive built a brick pond (single layer rendered inside and out) and pond seal and it didnt leak in the 5 years I owned that house,done it twice at 2 different houses, same results.
Bricks were free in Melbourne (if you asked the right person nicely),no bricks in Qld everything is blocks and you have to buy them.
They build swimming pools out of blocks here because you don't need a concreting expert just a block layer.
My other problem is no ute and miles from plastic tanks, yet close to a block supply and $40 delivery.
Bit of mucking around, at my pace, Petrocelli style, might be fun.
End result should look good.
Raised brick growbeds on cement sheet bases will be the experimental stuff.
My patio is just a suspended thick piece of cement sheet with tiles on it.


Top
 Profile  
Reply with quote  
 Post subject: Re: Cinder Block Tanks
PostPosted: Mar 16th, '11, 16:01 
In need of a life
In need of a life
User avatar

Joined: May 28th, '10, 15:40
Posts: 1508
Location: Strathfieldsaye Bendigo, VIC
Gender: Male
Blog: View Blog (1)
Are you human?: salmonid
Location: Bendigo - Central VIC
i seen them build a Retaining wall using those blocks and using Liquid nails to join them then filled with concrete as they went. think it was BHG or somthing.....

id be worried with No Physical Joins that it would all move n fall apart.

but jeez it looks good will consider something like this when we build.


Top
 Profile  
Reply with quote  
 Post subject: Re: Cinder Block Tanks
PostPosted: Mar 16th, '11, 16:56 
Moderator
Moderator
User avatar

Joined: Aug 26th, '10, 07:17
Posts: 9104
Gender: Male
Are you human?: YES
Location: Oregon, USA
Snags,

Your tanks were built with mortar? What about reinforcing rebar?


Top
 Profile  
Reply with quote  
 Post subject: Re: Cinder Block Tanks
PostPosted: Mar 16th, '11, 20:03 
Bordering on Legend
Bordering on Legend
User avatar

Joined: Jul 1st, '10, 21:20
Posts: 324
Location: Discovery Coast Qld
Gender: Male
Are you human?: occasionally
Location: Qld.
I built fish ponds in solid clay fired bricks

If I go the block route it will be with reo


Top
 Profile  
Reply with quote  
 Post subject: Re: Cinder Block Tanks
PostPosted: Mar 17th, '11, 08:26 
Moderator
Moderator
User avatar

Joined: Aug 26th, '10, 07:17
Posts: 9104
Gender: Male
Are you human?: YES
Location: Oregon, USA
Thanks for the info. Sounds like a really nice setup.


Top
 Profile  
Reply with quote  
 Post subject: Re: Cinder Block Tanks
PostPosted: Mar 19th, '11, 08:42 
Valued Contributor
Valued Contributor
User avatar

Joined: Apr 23rd, '09, 10:17
Posts: 78
Gender: Male
Are you human?: YES
Location: Edgar Springs, Missouri USA
I did not build a tank with dry stack but I did build my lower wall of greenhouse with them. I coated them with a surface bonding concrete and it is very strong.


Attachments:
Finished Walls.jpg
Finished Walls.jpg [ 270.77 KiB | Viewed 1947 times ]
Surface Bonding.jpg
Surface Bonding.jpg [ 264.45 KiB | Viewed 1945 times ]
DSC_0189.jpg
DSC_0189.jpg [ 278.25 KiB | Viewed 1944 times ]
Top
 Profile  
Reply with quote  
 Post subject: Re: Cinder Block Tanks
PostPosted: Mar 19th, '11, 08:53 
Valued Contributor
Valued Contributor
User avatar

Joined: Apr 23rd, '09, 10:17
Posts: 78
Gender: Male
Are you human?: YES
Location: Edgar Springs, Missouri USA
Also poured a concrete tank all at once. Kind of a pain but I did not know what i was doing, but it worked out. ended up having to fill voids with hydraulic cement and I painted it with a waterproof paint.


Attachments:
DSC_0359.JPG
DSC_0359.JPG [ 251.91 KiB | Viewed 1938 times ]
DSC_0387.JPG
DSC_0387.JPG [ 57.23 KiB | Viewed 1938 times ]
Top
 Profile  
Reply with quote  
 Post subject: Re: Cinder Block Tanks
PostPosted: Mar 20th, '11, 13:12 
Site Admin
Site Admin
User avatar

Joined: Mar 12th, '06, 07:56
Posts: 17803
Images: 4
Location: Perth
Gender: Male
Blog: View Blog (1)
Certainly looks like you know what you're doing.. :thumbright:


Top
 Profile Personal album  
Reply with quote  
 Post subject: Re: Cinder Block Tanks
PostPosted: Mar 29th, '11, 16:04 
Moderator
Moderator
User avatar

Joined: Aug 26th, '10, 07:17
Posts: 9104
Gender: Male
Are you human?: YES
Location: Oregon, USA
Finally got the computer set up and sort of working after moving everything to the new house, so I'm doing some catching up on my reading. Nice setup mmcelvy. I have to agree with Joel, it does look like you know what you're doing.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 25 posts ]  Go to page Previous  1, 2

All times are UTC + 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron

Powered by phpBB® Forum Software © phpBB Group
Portal by phpBB3 Portal © phpBB Türkiye
[ Time : 0.070s | 18 Queries | GZIP : Off ]