Heres what i used
1 x 40mm reducing T 40 x 25 at take off
1 x 3/4" x 1" poly director
1 x 100mm length 19mm poly
pressure glue PVC
2 x 12mm long button head stainless screws around 8ga
the T in the pic is 40 x 40 with a 40-25 reducer.. but you can get 40 x 25.. i just had none left
the one installed is 40 x 25
see pics for how it looks
put the 19mm poly on the director barb and press it into the 25mm socket on the T, you will need to shorten the poly a little. I made mine so it sat on the base of the T. once this length is correct, remove the director and poly piece and cut a section out of one side of the poly.
Run a little glue around the edge of the 25mm take off and press the director back in.... i put more glue on around this after i installed the director.. (more IS more)...make sure the cut out faces one ond of the 40mm T and then install the two screws into the side of the 25mm take off. this locks the director from turning when you put a fitting on it as there is not much of an adhered surface contact. give it a few minutes to dry and put it inline.
I put a VTOA (valve take off adaptor) socket one end fem thread the other) and a short length of pvc just in case it wants to push some water out at start up... but it didnt.
This is how i did mine, if it works for others, great.
| Attachments: |
|
venturi (1)2sml.jpg [ 98.54 KiB | Viewed 1941 times ] |
|
venturi (2)sml.jpg [ 85.65 KiB | Viewed 1941 times ] |
|
venturi (3)sml.jpg [ 87.21 KiB | Viewed 1941 times ] |
