All times are UTC + 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Nov 6th, '21, 22:12 
Offline

Joined: Nov 6th, '21, 21:55
Posts: 1
Gender: Male
Are you human?: yes
Location: Thornhill
Hello aquaponics community! I recently had a fantastic discussion with a professor doing aquaponics research and the topic of dissolved oxygen sensing came up. I am a scientist myself and during my research and I found a way to measure dissolved oxygen in a very simple and inexpensive way. I wanted to bounce some ideas off of you, the aquaponics community, to know what you actually want in a dissolved oxygen sensing device to help guide my R&D.

1) Do you monitor dissolved oxygen (for example, with a device that provides real-time data feedback), or do you check it when you feel something needs to be done/there is a problem? If you check it, how often do you do so? And do you prefer chemical tests or a device?

2) Would you want a device that can monitor dissolved oxygen? For example, a battery powered, bluetooth device that connects to your computer/phone and provides real-time data.

3) How long would you want to monitor dissolved oxygen for? For example, would you just want to see fluctuations over a weeks time? A few days after making some changes to your setup? Or maybe all the time?

4) Would you want this device to have an alarm in case levels go too high/low?

These are really all the questions I have for now and I am more than interested to talk about this with you. As a chemist, I know very little about aquaponics, but I know a lot about oxygen sensors! I am hoping to make a difference and assist the aquaponics and hydroponics community as much as possible. Thank you :)


Top
 Profile  
Reply with quote  
    Advertisement
 
PostPosted: Nov 9th, '21, 23:18 
Offline
Legend Member
Legend Member

Joined: Jan 6th, '15, 06:49
Posts: 734
Gender: Male
Are you human?: usually
Location: Santee, CA USA
Good questions. There is a person that developed a monitoring system marketed as Aquashield (aquashieldcontrol.com). I believe this includes a DO sensor and monitoring. There are a few others too, but I'm not sure any of them actually succeeded and are commercially available.

For my answers to your questions, I do not monitor DO. I do have both a probe (Milwaukee MW600) and a Salifert titration kit for DO. I do not like the titration kit as the nuances in judging the color are difficult. The MW600 works well, but is a laboratory instrument and must be handled properly, calibrated, maintained, etc. So when I dig it out of the box and put it to use, it is a bit of a pain.

My preference for all parameters including DO is for real-time monitoring and historic charts to map trends and relationships. However, it is not important enough (or critical enough) for me to spend significant funds. If I do pursue this, I will likely build an Arduino based system and add the sensors and communication that works best for me.

_________________
800 gal sys 2016
IBC sand-ponics system 2021, 3 IBC GBs

9 kW Solar Electric 2011 - Upgraded to 12 kW 2019

"Aquaponics...solar-powered nanotechnology that produces fresh vegetables and meat, while purifying water..." - Rick Op, Houston Texas.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC + 8 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Powered by phpBB® Forum Software © phpBB Group
Portal by phpBB3 Portal © phpBB Türkiye
[ Time : 0.056s | 18 Queries | GZIP : Off ]