| Backyard Aquaponics http://byap.backyardmagazines.com/forum/ |
|
| Hardware http://byap.backyardmagazines.com/forum/viewtopic.php?f=8&t=12091 |
Page 1 of 1 |
| Author: | peterhh [ Mar 16th, '12, 14:07 ] |
| Post subject: | Hardware |
I have a used ibc (2005) with no bottom valve or end cap. The thread is not 2" BSP male, there are only 3 very large threads, can anyone identify the thread and where I may get an end cap. Also what is the 1/2" female thread where the valve used to sit back from the end cap thread? Need a plug for this also. Any help appreciated |
|
| Author: | ccBear [ Jul 26th, '12, 06:17 ] |
| Post subject: | Re: Hardware |
Depends where you are, if Australia go to an irrigation or farm supply co op and ask them. I just got one to go on the valve with 40 mm male fitting for a cap. You can also get female ends for a plug. Not cheap. |
|
| Author: | bunson [ Jul 26th, '12, 09:38 ] |
| Post subject: | Re: Hardware |
http://www.backyardaquaponics.com/forum/viewtopic.php?p=207723#p207723 Take a photo of your IBC fittings and these people will help; well they assisted me a while ago! Scott |
|
| Author: | earthbound [ Jul 27th, '12, 11:27 ] |
| Post subject: | Re: Hardware |
There are a few places around that supply parts.. http://www.spacepac.com.au/Brochures/DS ... 3pg_np.pdf http://www.tankmanagement.com.au/conten ... -parts.seo http://www.industrialpackaging.com.au/i ... ories.html |
|
| Page 1 of 1 | All times are UTC + 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|