Ryan wrote:
Just reading that whole mess on ruperts thread got me going this morning. The HQ forum is a joke if thats one of their main voices coming over here to sling shit. Just a big love fest between him and the mod/web site owner who thinks it's doing his web site some good. I probably direct 20+ clients a week to Ap websites and I can assure you they wont be getting any recomendations from me. As we say in the states, go on brush your shoulder off...haters gonna hate. I don't agree with everything everyone has to say but calling someone out like you are the authority on the subject just to stir the pot? Get a life you interweb nerd.
Yeah, bit of a pity I bothered to react last night instead of just going to bed....
Funny how, despite claims that he couldn't register on this forum.. the poster arrived quick smart... and proceeded to post in a single thread with only an obvious desire to attack me...
Yet, having asked for an open letter to be posted on the HQ forum... so that everyone would be aware of the full context of what my response was... the request was declined... and an invitation offered to register a log in on HQ...
I did that nearly 24 hours ago.... and still haven't received a confirmation email that would allow me to actually post on that forum...
Wonder why... am I surprised... not at all....it's entirely consistant with the long history of that forum...
Throw shit.. and refuse the right to reply... or edit/moderate any response... selectively quote/misquote responses... and ultimately ban if you disagree...
Anyway, I've contacted the client concerned and directed them to the relevant posts...
Their response...amid a degree of laughter, and comment that I was definitely "not on someone's Xmas card list"...
Was that they was entirely satisfied with the advice given to them since the inception of the project, subsequent decisions relating to budgetary constraints and the likely impacts, the stocking of the trout and actions that might be required... acknowledged that I had outlined the possible constraints and accepted that the decision to go ahead was made by themself, and that actions taken and reasons for them following her departure... were fine by them...
And said that if they had not departed, they would have either eaten the stock.. or purchased an intended smoker and culled/smoked and refrigerated them...
The client also indicated that they would either, proceed with the purchase of a chiller, or a change of species in light of events... upon their return… ... as was always intended and/or outlined to the client… and that I should proceed as I saw fit to maintain the system in their absence..
The bit that really narks me is the new assertion that the poster boldly predicted that the system would fail... seemingly a prediction made only to themselves and/or an undisclosed "secret squirill" group of others... apparently based on the "design"… although from his last post on HQ... it would seem obvious that he has no idea of the operating principles of the "flood & drain" method employed at the site...and/or within the kit systems used...
Quote:
Speaking about "pumping cycles", I wonder if pumping water out into a "HOT" house letting it bake for 45 minutes then bringing back to the fish tanks for 15 minutes, would it have anything to do with thermal gain?...
And actually just made some assumptions based on their own aquaculture/RAS experience/perpective… which I'm happy to acknowledge... and perhaps some basis of comparison to a previous RAS, (and totally unrelated) system design within the same area...
Seemingly, despite the above... the poster is not only an aquaculture expert, but a thermal modeller, and an aquaponics expert...
To be clear...
I don’t expect that the poster is aware of all, or even any, of the discussions between the client and myself… or the budgetary constraints imposed… (and I can assure everyone that serious horse trading was involved)….but as such… any conjecture made in regard to any advice I offered… is just pure supposition..
I do not oppose the concept of external filtration and/or solids removal… indeed beyond a certain scale, and/or methodologies employed… it is often not only desirable… but mandatory…
But it does come with a cost overhead… which is often beyond what the purchasers of an aquaponics kit system are prepared to pay…
The question then becomes, do the kit systems available and principles employed…meet the desired outcomes within acceptable risks…
And I maintain, and a wide range of systems worldwide would seem to attest to… that they can….
As long as they are operated within certain stocking limitations…. And in that regard I have been consistent in my posts … and consistently opposed to any densities above 30kg/1000L… and even the moderator of the HQ forum, albeit privately, acknowledges that…
To suggest otherwise, as the poster has done is just not factual…
I consistently recommend lower densities than even the maximum suggestions to all my clients….
My home systems are not based around actual kit componentry, although I do utilise some grow beds… but I do abide by the general design principles…
My stocking levels have at times exceeded the levels I recommend to clients, visitors, and even members of the forum(s)… sometimes deliberately in order to test the limits, or verify suggested limits that others have suggested… sometimes due to expected short term stock holding…
And yes, at times that has caused problems, and (in relation to total numbers passing through my systems) sometimes small numbers of fish kills…
I’ve also lost fish due to equipment failure or natural events… often in my absence…
Could they have been avoided… probably… with an appropriate budget and time availability…
The fact that I may at times stock beyond what I consider safe levels for client kit systems… does not imply that I recommend that any clients do so… in fact it actually reinforces my advice not to do so…
Each time, such experiences hone my recommendations to clients…
All my home systems are currently being re-designed… mostly due to experience(s) I have learnt from over the last few years… as fast as time and budget allows…
Many an animal, and even fish… have been killed in the name of research and development… including the development of pond/sea & RAS quaculture systems… as they are & have been even in commercial operation…
As Netab posted, with the years of accumulated scientific research and resulting knowledge… putting together a RAS system within any budgetary or climatic constraints… is relatively easy…
And they almost always only proceed if appropriate budgets are available.
Backyard aquaponic systems are almost always budget constrained… and as such at times don’t incorporate measures that might mitigate against detrimental events…
And yes, there is a duty of care that revolves around the welfare of the fish in aquaponic systems… home based… or kit based…
And the kits available…are designed within such concepts… as long as they operated within appropriate stocking densities… some aren’t… and I take exception to the stocking densities that some people suggest…
I do not recommend to my clients that they stock beyond certain levels, especially in a new system… and I defy the poster, or anyone else to prove otherwise…
There is a possible “history” between myself, and forum members… and Crusty that goes back to early days on this forum…
viewtopic.php?p=24039#p24039Those posts and others in other threads resulted in Crusty’s shortlived appearance on the forum…
And are possibly the reason for his singling out of myself.. as an “example”…. Although I believe it’s probably more to do with his recent appearance after 4 years of non-involvement in aquaponics… and his own recent foray into the “industry” of aquaponics… and an attempt to build an image of authority by denigrating others…
Frankly… it’s just not necessary… Crusty has built some well thought out, well designed and implemented system to date… within budgetary limits that many, including myself might envy…
He may come from a different starting point… but that point can only be sustained within a level of budget provision…
If you think you can design a better aquaponics kit system to meet the current backyard aquaponics price market Crusty… go ahead and do it…
I’ve seen various suggestions made in that regard by a few people through the years… and none of them has been able, or prepared… to do it…
Why not put your expertise to good use Crusty… rather than denigrating others… if you can achieve it… you’ll capture the market… and put all us no-hopers out of business anyway…