Thanks for the reply Keith.
My basement is heated and insulated so shouldn't go below 18C in winter (~65F I think?) although I haven't actually checked what the temperatures are down there... Also with it being a south facing walkout it gets plenty of sun heating when the sun is out.
I looked into the other fish you suggested but I can't find a supplier anywhere nearby. I've only found 2 suppliers within an hours drive, one has tilapia the other has rainbow trout.
Predator mites from what I've read like cool humid conditions which is the opposite to what I have here (average humidity is below 40% with the exception of June which is usually quite humid) Is there a specific type that is better suited to the dry?
Here's a couple ideas I'm playing with:
Attachment:
File comment: Overhead shot
aqua1.jpg [ 55.26 KiB | Viewed 1460 times ]
This is the overhead shot each square is 1mx1m and the long rectangles are 1.5m x 1m
Initially I'd go with just 1 tank section and 1 growbed section to get things going.
Then I have to ideas for the vertical layout
Attachment:
File comment: Idea 1
aqua2.jpg [ 61.35 KiB | Viewed 1460 times ]
I like this design because it has a single pump and it pumps clean water instead of water from the fish tank which will also prevents the fish tank from ever running out of water. The downside is the fishtank is raised up above floor level which makes feeding more difficult and needs a lot more structure to hold it up. I didn't draw all the growbeds in to keep it simple to understand.
Attachment:
File comment: idea 2
aqua3.jpg [ 59.55 KiB | Viewed 1460 times ]
I like this design for having the fish tank lower to the ground but it also has the pump pushing dirty water which isn't great for the pump I'm guessing and it also has separate pump for the sumps which isn't ideal because it could cause the fish tank to be pumped dry. Again I didn't draw all the growbeds in to keep it simple. I also drew the lines out of the distribution box in the wrong spots to keep it simple for this one (all lines out are out the bottom the line in goes to the top)
I am planning on the system being flood and drain using a simple distribution box (small motor powering a disk covering the pipes going to the growbeds that has a pie shaped cutout) so the pump will run all the time reducing the size required. I will probably go for having dual pumps to keep things going should 1 fail and dual motor distribution box (or possibly dual distribution boxes). I like my fail safe systems
Cheers!
Bob