Backyard Aquaponics
http://byap.backyardmagazines.com/forum/

NFT channels and pressure filters
http://byap.backyardmagazines.com/forum/viewtopic.php?f=35&t=10620		 Page 1 of 1
Author:  Wal [ Oct 3rd, '11, 17:12 ]
Post subject:  NFT channels and pressure filters
OK here goes. I have a quite heavily stocked set up and my Barra are just getting bigger and bigger. One of my FT's feeds NFT channels and the piping drops to a 4mm retic pipe on the feed side of the channels. I am having issues with the smaller tubes blocking up every 3 days with gunk.

I am considering adding a Claritec 5000 Pressure Filter on the feed line to remove any "heavies" and also add some biological control. I will also upgrade my pump to be able to pump a little more sludge and scales around.

This web site gives a good overview of the filter.

http://creativepumps.com.au/zpumps/pond_one/claritec.htm

Any thoughts or experience out there with this kind of set up?

Cheers Wal

Attachments:
File comment: Claritec pressure filter
claritec_3000.jpg
claritec_3000.jpg [ 226.76 KiB | Viewed 3577 times ]
Author:  mantis [ Oct 3rd, '11, 17:43 ]
Post subject:  Re: NFT channels and pressure filters
Should work well Wal. I have one and have used it in a few different situations but it does clean up the water going through it well.
With the volume you might be putting through it , a back flush every couple of weeks would probably be needed but its not a biggy.
Page 1 of 1 All times are UTC + 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/